Recent posts

#21
Hello. I bought a second-hand Huntron Access 2, unfortunately, it does not have the main camera. What type of DFK camera and lens should I use for it to be correct? Thank you in advance for the information.
#22
Out of Production Hardware / Re: Huntron Tracker 2500 Manua...
Last post by Ljcttech - December 28, 2023, 03:06:50 PM
Okay thank you for the help.
#23
Out of Production Hardware / Re: Huntron Tracker 2500 Manua...
Last post by admin - December 27, 2023, 06:25:32 AM
The power supply section is on the main pcb. The schematics are linked earlier in this thread. As JVTHorsley suggests, check all of the caps and diodes that go to ground and the regulators U11 and U12.
#24
Out of Production Hardware / Re: Huntron Tracker 2500 Manua...
Last post by jvthorsley - December 23, 2023, 08:30:55 AM
Hi
Is the PSU a separate unit on the 2500.
If so does the fuse still blow with PSU isolated from the logic circuit board.
Blowing fuses normally caused when large capacitors or Diodes fail on the bridge rectifier section on the mains input.
#25
Out of Production Hardware / Re: Huntron Tracker 2500 Manua...
Last post by Ljcttech - December 22, 2023, 09:12:31 PM
I have problems my huntron 2500 keep blowing fuse.  Any tips be helpful. 
#26
Out of Production Hardware / Re: Protrack KJ2 EEPROM
Last post by fetron - December 21, 2023, 01:22:41 AM
Dear Admin!

The firmware number 06-5098 that you uploaded on December 14 belongs to the KJ4.

Firmware 06-5069 is for the KJ2 (which Ken needs).
Can you upload this?

#27
Out of Production Hardware / Re: Protrack KJ2 EEPROM
Last post by jvthorsley - December 18, 2023, 05:18:08 AM
I find this Programmer always works with the ProTrack Flash Proms.
#28
Out of Production Hardware / Re: Protrack KJ2 EEPROM
Last post by fetron - December 17, 2023, 02:54:42 AM
Hi Ken!

Make a copy in the good flash and save it in the hex format.

Program your new ic in the hex format.

It is not necessary to buy a new programming tool.
#29
Obsolete Software / Re: Workstation 3.5.4 sigAssis...
Last post by Al1234 - December 16, 2023, 12:26:44 PM
I think I am getting the hang of using the SigAssist as I use the program more.
It can be used in saved signature and zoom windows.

Thank you, fetron and Admin.
#30
Out of Production Hardware / Re: Protrack fails volt check
Last post by Al1234 - December 16, 2023, 12:16:27 PM
preformed an Auto Cal it fixed the voltage check failing.
Thank you fetron for sharing that one in previus posts a while back.
Later, I will try to find and put link to that post here.
https://huntron.com/forum/index.php?topic=324.msg1339#msg1339