Software Suggestions

Software Suggestions
« on: October 24, 2016, 07:37:30 am »
I had a few suggestions about software capabilities. I wanted to know what you all thought about them and their feasibility on implementation.

1. A "Step Back"/"Undo" button for coordinate data.
Sometimes when doing an offset, alignment, or setting pin coordinates, I've accidentally clicked somewhere on the PCB Image/ Prober window. Its not hard to relocate where I was, but it would be nice to have five to ten of the most recent locations stored in a back button.

2. A "Tracking Box" for the PCB Image.
A small transparent box in the PCB image that shows what the Prober window is viewing.

I had a few more that I can't remember, but any thoughts on these?
Thanks in advance!

admin

  • Huntronian
  • 329
    • HUNTRON.COM
    • Email
Re: Software Suggestions
« Reply #1 on: October 24, 2016, 08:12:46 am »
Hi,
Thanks for the suggestions. It is important that users give us feedback so we appreciate it!

The StepBack suggestion is interesting. I can see a one back capability being useful but 5 to 10 would probably be overkill.

Marking the camera view on the PCB Image is already on our wish list and hopefully will be incorporated soon.

I will pass this information on to engineering.
Thanks!

Admin
The most important troubleshooting tool is your eyes.

Re: Software Suggestions
« Reply #2 on: February 18, 2018, 02:12:42 am »
Hello Huntronian, was this ever implemented? It would fit our needs perfectly.

admin

  • Huntronian
  • 329
    • HUNTRON.COM
    • Email
Re: Software Suggestions
« Reply #3 on: February 19, 2018, 08:09:17 am »
Neither of these suggestions are in the current release. I would like to the see the camera position in the Board Image very much, though. I will keep pushing that one.
The most important troubleshooting tool is your eyes.